I installed the UUC Street EVO (height adjustable) short shifter.

I also installed the cartridge bearing upgrade. I have the delrin carrier bushings, I just can not get the old pin out, to change them. The pin must be rotated to remove, but I can only rotate it about half of the necessary distance before it hits the bottom of the car. I assume I will need to lower the rear of the tranny to complete this, I am just not sure what is involved in that. I also purchased the UUC aluminum shifter knob, which feels and looks really nice!

The cartridge bearings seemed to transmit quite a bit of transmission noise through to the shifter at first. After a bit, this seems to have gone away. The shifter feels very nice, however.